Note: due to massive spam issues, the forum registration is now closed. If needed, you may still contact me at the following address:

Submitted by Anonymous on Fri, 02/19/2010 - 00:53
in

Not sure if im doing something wrong but when I use this great tool with WinPE3 I do not see the fonts I just see the icon. Any suggestions?

Thanks,

Alan

‹ About Disconnection program path ›



Submitted by Laurent on Sat, 02/20/2010 - 15:18.

Did you select to have the text displayed below the icons? It's in Configuration > Apperance > Label position

Also the font being used is Arial so make sure it's installed on your system (normally it should be).